Samsung MX-JS5000 - Radio and Timer Settings; Storing FM Radio Stations; Selecting Stored Stations; Setting the Clock

Listening to the Radio
To Store the Stations You Want
You can store up to15 FM stations.
1.
Select FM by pressing the TUNER button.
2.
To search for a station, press the TUNING
MODE button on the remote control or the
STOP button on the product one or more
times until MANUAL is displayed.
3.
Select a station by:
- Pressing and holding the TUNING
1
,
2
button on the remote control
to automatically search for active
broadcasting stations.
4.
Press the MO/ST button to switch between
stereo and mono.
•
In a poor reception area, select MONO
for a clear, interference-free broadcast.
•
This applies only when listening to an
FM station.
5.
If you do not want to store the radio
station found, go back to Step 3 and
search for another station.
Otherwise:
a.
Press the MEMORY button.
• FM followed by a flashing number appears
in the display. That number is the current
preset number.
b.
Press the
1
,
2
button or the
,
,
.
buttons to scroll through and select a
preset number.
• You can select a number from 1 to 15.
c.
Press the
¬
button to save the preset.
6.
To store additional radio stations, repeat
Steps 3 to 5.
| NOTES |
✎
In Tuner mode
- In the Manual mode, you can use the
1
or
2
button to change stations.
- In the Preset mode, you can use the
1
or
2
button to search for a stored radio
station.
Selecting a Stored Station
To listen to a stored station, follow these steps:
1.
Select FM by pressing the TUNER button
on the product or remote control.
2.
Press the TUNING MODE button on the
remote control until “PRESET” is displayed.
3.
Press
1
,
2
button on the main unit or
TUNING
1
,
2
on the remote control to
select a preset number.
Timer Function
Setting the Clock
For each step, you have a few seconds to set
the required options. If you exceed this time,
you must start again.
1.
Press the TIMER SET button on the remote
control twice. "CLOCK " is displayed.
2.
Press the
¬
button on the remote
control. The hour flashes.
•
T
o increase the hours:
,
•
To decrease the hours:
.
3.
When the correct hour is displayed, press
the
¬
button, and then the minutes
flash.
•
To increase the minutes:
,
•
To decrease the minutes:
.
4.
When the correct minute is displayed,
press the
¬
button, and then " TIME"
appears in the display.
Setting the Timer
The timer enables you to set the product to
switch on or off at specific times automatically.
•
Before setting the timer, confirm that the
current time is correct.
•
For each step, you have a few seconds to set
the required options. If you exceed this time,
you must start again.
•
If you no longer want the product to be
switched on or off automatically, cancel the
timer by pressing the TIMER ON/OFF button.
Functions
22 English
02793F-MX-JS5000-ZA-ENG-20150224.indd 22 2016/2/3 15:32:53