© 2010 Samsung Electronics 5
Chapter 2
Using the DOS SSD Firmware
Utility
IMPORTANT: The following section assumes that DOS SSD FWD UTIL has been
properly installed. Before proceeding, be sure to:
Successfully complete the entire DOS SSD FWD UTIL installation
process as instructed in the “Setting Up and Configuring Your
System” on page 2 section
Starting DOS SSD Application
The DOS SSD application is launched from the USB.
[Warning]: DOS SSD FWD UTIL will execute only in IDE/ATA or AHCI
mode. Please check the BIOS setting and set drive mode/
configuration to Native/Compatible/Legacy/AHCI modes.
To Next Page
Loading...
