Samsung PPM42M5H - Rear Panel

Control Panel (continued)
➢
The actual configuration of your PDP Monitor may be different,
depending on your model.
Rear Panel
a) POWER IN
Connect the supplied power cord.
b) EXT SPEAKER (8Ω)
Connect external speakers.
c) PC1 IN/OUT
- IN : Connect to the video output jack on your PC.
- OUT : Connect to the video input jack on
external devices.
- AUDIO : Connect to the audio output jack on
your PC.
➢
AUDIO is an audio input jack for PC1 and PC2
modes.
d) PC2 (BNC) IN
Connect for RGB(Y/PB/PR)HV video signal input from
the PC.
➢
“PC Mode” from this page onward means
PC1/PC2 mode using
RGB1(PC1) and
RGB2(PC2).
e) RS-232C
- IN : Used for the MDC function when connecting
PC or RS-232C output of another PDP
Monitor.
- OUT : Used for the MDC function when
connecting with RS-232C input of another
PDP Monitor.
➢
For further details about connections, refer to
Page 12.
f) DVI IN
- DVI : Connect to the video output jack for device
with DVI output.
- AUDIO : Connect to the audio output jack for
devices with DVI output.
g) COMPONENT IN
Video (Y/PB/PR) and audio (L/R) inputs for
component.
h) AV (VIDEO/AUDIO L/R)
- IN : Video and audio inputs for external devices,
such as a camcorder or VCR.
- OUT : Outputs for external devices.
i) S-VIDEO IN
Video input for external devices with an S-Video
output, such as a camcorder or VCR.
a
b
c
➢
d
➢
e
➢
English - 7
➢
For further details about connection, refer to pages 43~46.
➢
Whenever you connect an audio or video system to your PDP Monitor, ensure that all elements are
switched off. Refer to the documentation supplied with your equipment for detailed connection
instructions and associated safety precautions.
c
BN68-00848A-00Eng_0404 4/4/05 3:57 PM Page 7