Media and tray
40
2. Menu Overview and Basic Setup
• If envelopes are printed out with wrinkles, creases, or black bold lines,
open the rear cover and pull down the pressure lever on the right side
about 90 degrees and try printing again. Keep the rear cover opened
during printing.
1 Pressure lever
• When you are printing on an envelope, close the output support.
Otherwise, paper jam may occur.
1 Output support
• When selecting envelopes, consider the following factors:
- Weight: should not exceed 90 g/m
2
otherwise; jams may occur.
- Construction: should lie flat with less than 6 mm curl and should not
contain air.
- Condition: should not be wrinkled, nicked, nor damaged.
- Temperature: should resist the heat and pressure of the machine
during operation.
• Use only well-constructed envelopes with sharp and well-creased folds.
• Do not use stamped envelopes.
• Do not use envelopes with clasps, snaps, windows, coated lining, self-
adhesive seals, or other synthetic materials.
1
1
To Next Page
Loading...
