SAFETY PRECAUTIONS FOR AS
● Upon electronic Control system repair/change,make sure the set unplugged.
Be ware of electric shock.
● Use rated electronic Control equipment.
Make sure to check out ModeL name,Rated voltage,Rated current,Operation Temp,etc.
● Upon repair,make sure that harnesses are not to be water-penetrated and are bundled tight.
Should not be detached by a certain amount of external force.
● Upon repair,completely remove dust or other foreign substances from housing,harness,
connector,etc.
To prevent fire by tracking,short,etc.
● Check out whether water has penetrated into the electronic Control system.
If there is any kind of trace,take necessary measures such as related component change,
insulation tapping,etc.
● After repair,check out the assembled state of parts.
It should be the same as the previous state.
● Check out the surrounding conditions.
Change the location,if the fridge is located at humid,wet places or the installed state is unstable.
● If needed,ground the fridge.
Especially,if there is a possibility of electric leakage,ground is indispensable.
● Do not allow consumers to overload a certain outlet.
● Check out whether the power cord or the outlet is broken,squeezed,chopped off or heat-
deformed.
Repair or replace the defective power cord/outlet immediately.
Make sure the power cord is not punctuated or stomped down.
● Do not allow consumers to keep food unstable or place bottles in the Freezer Room.
● Do not allow consumers to repair the fridge for themselves.
● Do not allow consumers to keep things except for food.
Pharmaceutical,Chemical substances :These are not possible to be fine-Controlled with a
consumer fridge.
Flammable material (alcohol,benzene,ether,LPG,etc):possibility of explosion.
To Next Page
Loading...
