Setting upyour French Door Refrigerator
4. Remove the filter cap and insert the filter into the filter
housing.
5. Slowly turn the water filter 90° clockwise to align with the
printing mark on the cover, locking the filter in position.
Make sure to align the water filter label mark with center
of cover filter printing as illustrated. Remember, do not
over-tighten.
6}
/
Separation
of red cap.
Cover filter. @
i..111,7
Turn until the
label aligned.
_You should remove the right side upper glass shelf before installing water filters.
Removing any residual matter inside the water
supply line after installing the water filter.
1. Turn ON the main water supply & turn OFF the valve to
the water supply line.
2. Run water through the dispenser until the water runs
clear (approx. 6-7 minutes). This will clean the water
supply system and remove air from the lines.
3. Additional flushing may be required in some households.
4. Open the Refrigerator door and make sure there are no
water leaks coming from the water filter.
OneTouch Pure Water
_A installed water filter water to from the water _:;
newly cartridge
may
cause
spurt dispenser.
Check the amount of water supplied to the ice tray.
1. When you press the TEST button, the ice cube container is filled with water from the water supply
tap. Check to make sure the amount of water is correct (see the illustration below).
If the water level is too low, the ice cubes will be small. This is a water pressure problem of
the main water pipes, not the Refrigerator. If this problem occurs, contact the dealer service
center for help.
18 Setting Up
To Next Page
Loading...
