REATTACHING THE REFRIGERATOR DOORS
Assemble the Refrigerator doors
1. Reattach two flat head screws(G ) and two hex head
screws(G ) to the hinge completely.
2. Place the hole in the bottom of the door([_)over the lower
hinge (_})
[_Be aware not to miss the hinge cap because it can
be easily taken off.
3. Insert the upper hinge shaft((_) into the hole on the
corner of the Refrigerator door(G ). Make sure the
hinge is level between the upper hinge hole(G ) and the
hole of the cabinet(G ) and reattach the hinge screws(
_) and ground screw(G ) by turning in a clockwise
direction. Reconnect the wires.
%
4. Place the front edge of the top table(_}) on the front of
the upper hinge((_) and reattach with three screws.
_When reattaching top table, sure
the make that the
wires are not pressed or damaged by the top table.
Setting Up _11
To Next Page
Loading...
