23
1.Pull the shelf out as far as it goes.
2.Lift it up and pull it out from the unit.
1.Remove ice bucket.
2.Remove the screws(4) that secured the case
3.Slide it out from the unit. then, you can
disassemble the auger motor from the
back of the case.
1. Remove ice bucket and the Ice maker.
2. Remove the covers(①) and sensor covers(②)
3. Remove the screws(3pcs) that secured the
assembly.
4. Disconnect the wire connector(③) and the
connecter for Sensor (it can be possible
to disconnect this connector after removing
the sensor cover)
1. Remove the assembly of cover multi freezer
2. Pull the assembly out toward front by holding
upper side of the assembly up to see the
connector.
3. Disconnect
the wire
connector
and take the
assembly out.
Ice Maker
Cover Multi Freezer Assembly
Cover Evaporator Assembly
Auger Motor & case
1 2
①
②
③
To Next Page
Loading...
