2929
DISASSEMBLY & REASSEMBLY
3-9) Interior-Freezer
① Pull the shelf out to the hole point.
② Remove it by turning and lifting it up.
Remove all Drawers before
disassembling the cover.
Pull the cover out to the hole point.
And then remove it by turning and lifting
it up.
① Insert a flat-blade screwdriver into the
slot as shown in the picture and turn
the screwdriver gently.
② Pull out the Cap Sensor.
Disengage the housing connector of the
Sensor(the left one of the two).
Take off the seal carefully for reuse.
Disassemble and replace the Sensor.
PART NAME DESCRIPTION
Shelf
Drawer
Cover
Sensor
(Freezer)
FIGURE
To Next Page
Loading...
