Installation
English24
Installation
STEP 2 Spacing (applicable models only)
1. Open the door and locate the provided
spacers (x2).
2. Unpack both spacers and attach them
to the rear of the refrigerator as shown.
They help ventilate air to the rear wall
and save power consumption.
STEP 3 Flooring
• The surface to install the refrigerator
must support a fully loaded refrigerator,
or approximately 90 kg.
• To protect the oor, put a large piece
of cardboard on each leg of the
refrigerator.
• Once the refrigerator is in its nal
position, do not move it unless
necessary to protect the oor. If you
have to, use a thick paper or cloth such
as old carpets along the movement path.
STEP 4 Adjust the levelling feet
Level the refrigerator by manually
adjusting the levelling feet. Turn the
levelling feet clockwise to lower the
position, or turn counter clockwise to raise.
For safety reasons, adjust the front side a
little higher than the rear side.
Untitled-2 24 2021-02-25 10:50:25
To Next Page
Loading...
Need help?
General
