- 40 -
Using Anynet+ (HDMI-CEC)
Control an external device connected via Anynet+ (HDMI-CEC) with the remote control.
You can use the product’s remote control to control external devices that are connected to the product by an HDMI
cable and that support Anynet+ (HDMI-CEC). Note that you can only set up and operate Anynet+ (HDMI-CEC) with
the remote control.
Connecting an external device through Anynet+ and using their menus
Settings General External Device Manager Anynet+ (HDMI-CEC)
1. Set Anynet+ (HDMI-CEC) to On.
2. Connect an HDMI-CEC-compliant device to the product.
3. Turn on the connected external device.
The device is automatically connected to the product. After the connection process is finished, you can access the
menu of the connected device using your product remote and control the device.
" The connecting process can take up to 2 minutes to complete.
Read before connecting an Anynet+ (HDMI-CEC) device
" Anynet+ (HDMI-CEC)-enabled devices must be connected to the product with an HDMI cable. Note that some HDMI cables
may not support Anynet+ (HDMI-CEC).
" Anynet+ cannot be used to control external devices that do not support HDMI-CEC.
" The product remote control may not work under certain circumstances. If this occurs, set up the device as an Anynet+
(HDMI-CEC)-enabled device again.
" Anynet+ (HDMI-CEC) works only with external devices that support HDMI-CEC, and only when those devices are either in
standby mode or turned on.
" Anynet+ (HDMI-CEC) can control up to 12 compliant external devices (up to 3 of the same type) except for home theatres.
Anynet+ (HDMI-CEC) can control only one home theatre system.
" To listen to 5.1 channel audio from an external device, connect the device to the product via an HDMI cable.
To Next Page
Loading...
