36
Connecting and Using a Source Device
2
2 Connecting and Using a Source Device
2.2.8 Tidying Up the Connected Cables
Remove the COVER-CABLE by
sliding it down with both hands in
the direction indicated by the
arrow.
Install the cables into the cable
holder at the right side.
Hold the COVER-CABLE and fix
the cables into the grooves on
the STAND-REAR.
Hold the bottom of the stand
neck securely with your left hand
and use the thumb of your right
hand to slide up the COVER-
CABLE to fix it in place.
Installation is finished.
To Next Page
Loading...
