78
Setup and Reset
6
6 Setup and Reset
6.3 DisplayPort Ver.
Select your Displayport. Displayport 1.1 supports High Bit Rate 1, while 1.2 supports High Bit Rate 2.
z Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
z If the monitor (when set to DVI, HDMI or DisplayPort) is in power saving mode or is displaying the
message Check Signal Cable, press the [ ] button to display the On Screen Display (OSD).
You can select 1.1 or 1.2.
6.3.1 Configuring DisplayPort Ver.
1 Press any button on the front of the product to display the Function Key Guide. Next, press [ ] to
display the corresponding menu screen.
2 Press [ ] to move to Settings and press [ ] on the product.
3 Press [ ] to move to DisplayPort Ver. and press [ ] on the product.
The following screen will appear.
z 1.1 / 1.2
4 Press [ ] to move to the option you want and press [ ].
5 The selected option will be applied.
To Next Page
Loading...
