Samsung S49CG95 E Series

To Next Page

To Previous Page

2nd 3rd Description

Input Port Ver. Select an HDMI version. (1.4 / 2.0↑)

―

The supportable device and resolution may differ depending on its version.

―

When the version is changed, the screen may blink.

―

If you set the HDMI mode to 1.4, some high resolutions may not be supported because of bandwidth limitation of the HDMI 1.4 protocol.

―

When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the device.

―

Set HDMI mode to 1.4 if the monitor is connected to an HDMI device and the monitor does not display the screen properly, displays a blank screen, or does

not play sound at all.

Auto Source Switch+ By activating, a new connected source is displayed automatically.

―

This feature is available only when the monitor is turned on.

Key Repeat Time Control the response rate of a button when the button is pressed.

Acceleration, 1 sec, or 2 sec can be selected. If No Repeat is selected, a command responds only once when a button is pressed.

Power LED On Configure the settings to enable or disable the power LED located at the lower part of the product.

• Working: The power LED is on when the product is turned on.

• Stand-by: The power LED is on when the product is turned off.

Setup Custom Key Set the custom key so that your chosen function can be set up directly.

• Eye Saver Mode / PIP/PBP / Refresh Rate / Low Input Lag / Black Equalizer / Virtual Aim Point / Infinity Core Lighting / Auto Source Switch+ /

Picture Mode / Response Time

Best Brightness Optimises brightness in real time, based on your lighting environment.

Minimum Brightness Set the minimum brightness for Monitor screen. This function only works if its value is lower than the value set in the Picture menu’s Backlight

setting.

―

This option is available when Best Brightness is set to On.

VRR Control By optimising the video signal processing, this additional function mitigates screen flicker.

While playing any game or content that causes screen flicker, use the VRR Control function with setting it to On.