Samsung S49CG95 E Series - Standard Signal Mode Table

41
Standard Signal Mode Table
Model Name S49CG95*E
Synchronization (PANEL Spec) Vertical Frequency 96 ~ 240 Hz
Resolution Optimum resolution 5120 x 1440 @ 240 Hz
Maximum resolution
―
If dual monitor mode is used under DSC resolution conditions, the mode may not work properly due to the output limit of the graphics card. (DSC resolution: 5120 x 1440 @ 240 Hz or 3840 x 2160 @ 144 Hz)
If that is the case, lower the resolution of the sub-monitor or lower the Input Port Ver. or DisplayPort Ver. value set for your monitor.
If a signal that belongs to the following standard signal modes is transmitted from your PC, the screen will automatically be adjusted. If the signal transmitted from the PC does not belong to the standard signal
modes, the screen may be blank even though the power LED turns on. In such a case, change the settings according to the following table by referring to the graphics card user manual.
Resolution
Horizontal Frequency
(kHz)
Vertical Frequency
(Hz)
Pixel Clock
(MHz)
Sync Polarity
(H/V)
Port
HDMI IN 1 HDMI IN 2 DP IN
VESA, 640 x 480 31.468 59.940 25.175 -/- O O O
VESA, 640 x 480 37.500 75.000 31.500 -/- O O O
VESA, 720 x 480 31.469 59.940 27.000 +/+ O O O
VESA, 800 x 600 37.879 60.317 40.000 +/+ O O O
VESA, 800 x 600 48.077 72.188 50.000 +/+ O O O
VESA, 800 x 600 46.875 75.000 49.500 +/+ O O O
VESA
, 1024 x 768 48.363 60.004 65.000 -/- O O O
VESA, 1024 x 768 56.476 70.069 75.000 -/- O O O
VESA, 1024 x 768 60.023 75.029 78.750 +/+ O O O
VESA, 1280 x 1024 63.981 60.02 108.000 +/+ O O O
VESA, 1280 x 1024 79.976 75.025 135.000 +/+ O O O
VESA, 1152 x 864 67.500 75.000 108.000 +/+ O O O
VESA, 1280 x 720 45.000 60.000 74.
250 +/+ O O O
VESA, 1280 x 800 49.702 59.810 83.500 -/+ O O O