Samsung SCD-2020 - Separating Camera Components; Ceiling Bracket Mounting; Lens Replacement Procedure

COLOR DOME CAMERA User Guide
10
COLOR DOME CAMERA User Guide
11
1) Separate the dome cover by turning anti-clockwise.
2) Separate the shield case by pulling from the camera body.
•The installation should be done by qualified
service personnel or system installers.
•Iftheceilingmaterialisnotstrongenoughto
hold the installation screws, the camera may
falloff.Reinforcetheceilingasneeded.
•Tochangethepositionofthecable,take
awaytheHoleCoverandpassthecable
through.
Notes
* To install the dome cover on the camera
body, turn the latches in locking direction
as shown in the figure-1.
Installation
Installation
When using the Ceiling bracket
1) Hold the ceiling bracket (located where the arrow
points to) and separate it from the main body of
the camera by rotating it anti-clockwise.
(refer to the picture in 'Notes' on page 10)
2) Place the separated ceiling bracket so that the
“Front” side faces the area to be monitored and
install it with the M4 tapping screws.
3) To combine the main body with the ceiling bracket,
make sure that the pan base fixation screw face the
opposite side of the “Front” side of the ceiling
bracket and rotate it clockwise.
4) Adjust the camera lens to face the area to be
monitored and fix the main body and the dome
cover by aligning the grooves and rotating the
body clockwise.
When changing the additional lens.
1) Separate the built-in lens by anti-clockwise rotation and
combine wave washer and another lens. When combining the
lens, please clean the back side of lens and inside of the lens
holder.
2) Combining the lens by clockwise rotation, adjust the focus while
watching the monitor.
• Ifyouwanttoinstallthecamerawiththeceilingbracketcombined,fixitusingtwoM4tapping
screwsatthesideofthemainbody(refertothe[Figure-2]onpage11).
Notes
Installation
Latch
[Figure-1]
LockingDirection
(Clockwise)
DomeCover
Unlocking direction
(Anti-clockwise)
MainBody
(Camera)
Originalpositionof
the cable
HoleCover
Unlocking
direction
M4tapping
screw (provided)
Anarrowforinstalling
directions
DomeCover
Ceilingbracket
Lockingdirection
[Figure-2]
M4tapping
screw
PanBase
fixation
screw