Samsung SCD-2020 - Operating Your Camera; Exit Menu Options; Troubleshooting; No Image on Screen

COLOR DOME CAMERA User Guide
30
COLOR DOME CAMERA User Guide
31
Operating Your Camera
EXIT

LANGUAGE : You can select the menu language according to your requirements.
- NTSC : English, Korean, Japanese, Spanish, French, Portuguese, Taiwanese.
- PAL : English, Chinese, German, Italian, French, Spanish, Russian, Czech, Polish,
Romanian, Serbian, Swedish, Danish, Turkish, Portuguese.

RETURN : Select this to save the SPECIAL menu settings and return to the MAIN SETUP
menu.
Select a desired EXIT mode using the Function Setup switch depending on the camera
purpose.
- SAVE : Save the current settings and exit the MAIN SETUP menu.
- NOT SAVE : Do not save the current settings and exit the MAIN SETUP menu.
- RESET : Resets the camera settings to the factory defaults. Language and Monitor
settings are not initialized.
If you have trouble operating your camera, refer to the following table. If the
guidelines do not enable you to solve the problem, contact an authorized
technician.
●
Nothing appears on the screen.
▶ Check that the power cord and line connection between the camera and monitor are properly
connected.
▶ CheckthatyouhaveproperlyconnectedVIDEOcabletothecameraVIDEOoutputjack.
● The image on the screen is dim.
▶ Is lens stained with dirt? Clean your lens with soft, clean cloth.
▶ SetthemonitororDVRtopropercondition.
▶ If the camera is exposed to very strong light, change the camera position.
● The image on the screen is dark.
▶ AdjustthecontrastfeatureofthemonitororDVR.
▶ Ifyouhaveanintermediatedevice,setthe75Ω/Hi-zproperly.
● The camera is not working properly, and the surface of the camera is hot.
▶ Check that you have properly connected the camera to an appropriate power source.
● The DAY/NIGHT menu does not work.
▶ CheckthatAGCofEXPOSURESETUPmenuis‘OFF’.
● The SENS-UP function does not work.
▶ CheckthatAGCofEXPOSURESETUPmenuis‘OFF’.
▶ CheckthatSHUTTERofEXPOSURESETUPmenuis‘A.FLK’or‘MANUAL’.
● The Motion Detection function does not work.
▶ CheckthatMOTIONDEFofSPECIALSETUPmenuis‘OFF’.
● Color is not correct.
▶ Check the setting of WHITE BAL SETUP menu .
● The screen flickers continually.
▶ Check that direction of camera turns toward the Sun.
● When coaxial communication is not available:
▶ Make sure that the camera and monitor are installed within the recommended distance.
▶ Use the video amplifier equivalent to coaxitron if the recommended installation distance is exceeded.
Troubleshooting