Troubleshooting
If there are problems in operation, please refer to the items below. If the
problem persists, please contact the agent you purchased this product from.
•
Nothing appears on the screen.
▶ Check that the power cord and line connection between the camera and monitor are
fixed properly.
▶
Check that you have properly connected UTP cable or BNC cable to the camera.
•
The image on the screen is dim.
▶ Is lens stained with dirt? Clean your lens with soft, clean cloth.
▶ Set the monitor to proper condition.
▶ If the camera is exposed to too strong light, change the camera position.
•
The image on the screen is dark.
▶ Adjust the contrast feature of the monitor.
▶ If you have an intermediate device, set the 75Ω / Hi-z properly.
•
The camera is not working properly, and the surface of the camera is hot.
▶ Check that you have properly connected the camera to an appropriate power source.
•
The SENS-UP function does not work.
▶ Check that AGC of EXPOSURE SETUP menu is ‘OFF’.
▶ Check that SHUTTER of EXPOSURE SETUP menu is ‘A.FLK’ or ‘MANUAL’.
•
The Motion Detection function does not work.
▶ Check that MOTION DET of SPECIAL SETUP menu is ‘OFF’.
•
Color is not correct.
▶ Check the setting of WHITE BAL SETUP menu.
•
The screen flickers continually.
▶ Check that direction of camera turns toward the Sun.
•
When coaxial communication is not available:
▶
Make sure that the camera and monitor are installed within the recommended distance.
▶
Use the video amplifier equivalent to coaxitron if the recommended installation distance is
exceeded.
•
IR-LED isn’t lighted.
▶
Isn’t DAYNIGHT function setting up the color mode?
▶
Please change the AUTO or B/W mode.
•
The camera is not waterproof.
▶ Please check the Front Cover and Main Body by the following Guide Label.
Specifications
The specification for this product may change without prior notice for product improvement.
SCO-2080RN
SCO-2080RP
ELECTRICAL
Input Voltage DC 12V ± 10% / AC 24V ± 10%
Power Consumption Max 6.8W / 6.5W (IR-LED ON)
VIDEO
Imaging Device 1/3 inch, Diagonal 6mm Super HAD CCD
Total Pixels 811(H) x 508(V) 795(H) x 596(V)
Effective Pixels 768(H) x 494(V) 752(H) x 582(V)
Scanning System 2:1 Interlace
Synchronization Internal /Line-Lock
Frequency H : 15.734KHz V:59.94Hz H: 15.625KHz V: 50.00Hz
Horizontal Resolution
COLOR : 600TV line, B/W : 700TV line
Min. Illumination
LED ON : 0Lux
LED OFF : 0.15Lux (Color, F1.2), 0.0003Lux (Color,SENS-UP x512)
Visibility distanse(IR LED) 50m (32EA)
S/N (Y Signal) 52dB (Weight On, AGC Off)
Video Output CVBS : 1.0Vp-p, 75Ω composite
LENS
Zoom Ratio 3.6x (Manual)
Focus Length 2.8 ~ 10.0mm (F1.2)
Angular Field of View H : 94.4°(Wide) ~ 28°(Tele) / V : 69.2°(Wide) ~ 21°(Tele)
OPERA TIONAL
Electronic Shutter Speed
1/60 ~ 1/120k sec
1/50 ~ 1/120k sec
On Screen Display
NTSC : 7 Languages, PAL : 15 Languages
SSDR On / Off (Level adjustable)
Backlight Compensation BLC / HLC / OFF
Day & Night COLOR / B/W / AUTO (ICR)
Gain Control Low / High / Off
White Balance ATW / Outdoor / Indoor / Manual / AWC (1,700°K ~ 11,000°K)
SENS-UP (frame Integration) Auto / Off (Selectable x2 ~ x512)
Motion Detection On / Off (8 Programmable zones)
Privacy Masking On / Off (12 Programmable zones)
3D Noise Filter (SSNRIII) On / Off (Level adjustable)
Digital Zoom On / Off (x1 ~ x16)
Digital Image Stabilization(DIS) On / Off
Camera Title On / Off (Displayed 15 Characters)
Sharpness On / Off (Level adjustable)
Flip / Mirror On / Off
Communication Coaxial, RS-485
Protocol
Coaxial(Pelco), RS-485(SAMSUNG-T, SAMSUNG-E, PELCO-P, PELCO-D, VICON,
PANASONIC, BOSCH, HONEYWELL)
ENVIRONMENTAL
Operating Temperature / Humidity -10°C ~ +55°C / Less than 90% RH
MECHANICAL
Water Resistance IP66
Dimension Ø77mm(W) x 216mm(H) (BRACKET ANGLE 90°), 284mm (BRACKET ANGLE 180°)
Weight 1Kg
To Next Page
Loading...
