Preparation
2727
ENGLISH
Inserting and Ejecting a Cassette
✤ When inserting a tape or closing a cassette holder, do not apply excessive force.
This may cause a malfunction.
✤ Do not use any tapes other than Mini DV cassettes.
1. Connect a power source and slide the TAPE OPEN/EJECT switch
and open the cassette door.
- The cassette holding mechanism rises automatically.
2. Insert a tape into the cassette holder with the tape window facing outward
and the protection tab toward the top.
3. Press the area labelled PUSH on the cassette holding mechanism
until it clicks into place.
- The cassette is loaded automatically.
4. Close the cassette door.
- Close the door completely until you
can hear a “click”.
Note
When you have recorded something that you wish to keep, you can protect it
so that it will not be accidentally erased.
a. Protecting a tape :
Push the safety tab on the cassette so that the hole is uncovered.
b. Removing the tape protection :
If you no longer wish to keep the recording on the cassette,
push the write-protect tab back so that it covers the hole.
•
How to keep a tape
a. Avoid places with magnets or magnetic interference.
b. Avoid humidity and dust prone places.
c. Keep the tape in an upright position and avoid storing it in direct sunlight.
d. Avoid dropping or knocking your tapes.
DO NOT PUSH IN THE COMPARTMENT
1
DO NOT PUSH IN THE COMPARTMENT
3
2
4
a. SAVE
push
b. REC
00616B SCD23-SEA(01~27) 5/12/03 9:46 AM Page 27
To Next Page
Loading...
Need help?
General
