[ENGLISH]
Notices and Safety Instructions
9. VENTILATION:
Slots and openings in the cabinet are provided for ventilation to
ensure reliable operation of the CAMCORDER and to protect it
from overheating. These openings must notbe blockedor
covered.Never place your CAMCORDER on a bed, sofa, rug,
or other simitar surface: on or near a radiator or heat register.
This CAMCORDER should not be placed in a built-in installation
such as a bookcase or rack unless properventilation is provided
or the manufacturer's instructions have been adhered to.
10. POWER SOURCES:
The CAMCORDER should be operated only from the type of
powersource indicatedon the label
If you are not sure of the type of powersupply at your home,
consult your appliance dealer or localpowercompany,
A CAMCORDER is intendedto be operated from battery power,
or other sources, refer to the operating instructions,
11. GROUNDING OR POLARIZATION:
This CAMCORDER may be equippedwith eithera polarized
2-wire AC lineplug (a plug having one blade widerthan the other)
or a 3-wire grounding type plug,a plug having a third (grounding)
pin.
Ifyou are unableto insert the plugfully intothe outIet, try reversing
the plug,Ifthe plug still fails to fit, contact your electrician to
replace your outlet, Do not defeat the safety purposeof the
polarizedplug,
13. OUTDOOR ANTENNA GROUNDING:
Ifan outside antenna or cable system is connected to the
CAMCORDER, be sure the antenna or cable system isgrounded
to provide some protection against voltage surges and built-up
static charges, Section 810 of the National Electrical Code,
ANSI/NFPA No. 70-1984, provides information with respect to
proper grounding of the mast and supporting structure, grounding
ofthe lead-in wire and supporting structure, grounding ofthe mast
and supporting structure, grounding of the lead-in wire to an
antenna discharge unit, size of grounding to conductors, location
of antenna-discharge unit, connection to grounding electrodes
and requirements for the grounding electrode.
See figure below.
12. POWER-CORD PROTECTION:
Power-supply cords should be routed so that they are not likely to
be walked on or pinched by items placed upon or against them,
paying particular attention to cords or plugs, convenient
receptacles, and the point where they exit from the unit,
To Next Page
Loading...
