Changing Your Settings 147
USB Debugging
When enabled, allows debugging when the device is
attached to a PC by a USB cable.
Note:
This setting is used for development purposes.
1. From the Home screen, tap ➔
Settings
➔
More
settings
(System) ➔
Developer options
.
2. Tap
USB debugging
to enable or disable the setting.
When enabled, a check mark displays in the check
box.
Development device ID
The identification number for your device when using it as a
development tool displays in this field.
Allow mock locations
This setting is used by developers when developing
location-based applications.
From the Home screen, touch
Menu
➔
Settings
➔
Developer options
➔
Allow mock locations
to enable
or disable the setting.
A check mark indicates activation.
Desktop backup password
Protect the desktop with a backup password ID.
1. From the Home screen, touch
Menu
➔
Settings
➔
Developer options
➔
Desktop backup password
.
2. In the Settings screen, enter the current full backup
password, the new password for full backups, then
enter the new password again.
3. Touch
Set backup password
to save the password
change.
User interface
Configure the user interface by setting the behavior for the
way the screen behaves when using applications or
displaying data.
From the Home screen, touch
Menu
➔
Settings
➔
Developer options
, under the
User interface
heading,
touch the check box next to each of the following
options to enable: (A check mark indicates activation.)
• Strict mode
: The screen flashes when applications perform
long operations on the main thread.
• Show pointer location
: Highlights the data that was touched
on the screen.
DRAFT - Internal Use Only
DRAFT - Internal Use Only
To Next Page
Loading...
