DAY/NIGHT
You can specify a recording mode according to the scene.
Select <CAMERA SET> - <DAY/NIGHT>.
Select a screen transition mode according to
the illumination, and set options as appropriate.
DAY : Fixed to DAY mode, regardless of the
scene.
NIGHT : Fixed to NIGHT mode, regardless
of the scene.
If BURST is set to <ON>, the burst signal
will be output along with the black-and-
white composite video signal.
AUTO : According to the luminance, this will
switch DAY to NIGHT mode, or vice versa.
BURST : If set to <OFF>, the burst signal will
not be output in NIGHT mode.
DAY
NIGHT BRIGHTNESS : Specify the
brightness level switching from COLOR to
BW filter.
Adjusting from HIGH to LOW will cause to
switch the filter in a darker screen.
DAY
NIGHT DWELL TIME : Time
required to determine the filter switch.
NIGHT
DAY BRIGHTNESS : Specify the brightness level switching from BW
to COLOR filter. Adjusting from HIGH to LOW will cause to switch the filter in a
darker screen.
NIGHT
DAY DWELL TIME : Time required
to determine the filter switch.
MASK AREA : If there exists a bright spot
light source in a night scene, you can
specify the size and position as needed.
This will prevent an error in switching filter,
or failure to determine the filter switch in
a night scene where a bright spot light
source exists.
Any excessively bright area in a night scene
will be MASKed.
You can specify MASK 1 and 2 simultaneously.
1.
2.
-
-
-
-
-
-
AUTO
BURST OFF
DAY
NIGHT
BRIGHTNESS MID
DWELL TIME 2SEC
NIGHT
DAY
BRIGHTNESS MID
DWELL TIME 5SEC
MASK AREA
1 2
MASK AREA
<SIZE>
<LOCATION>
DAY/NIGHT AUTO
WHITE BAL
FOCUS MODE ONEAF
ZOOM SPEED [
3
]
DISPLAY ZOOM OFF
DIGITAL ZOOM OFF
DETAIL [
2
]
V-SYNC (INT)---
AGC COLOR SUP MID
To Next Page
Loading...
