Samsung SCX-5935FN - Page 134

Alignment & Troubleshooting
Service Manual
4-83
Samsung Electronics
4.2.3.4 Malfunction
Error Status Check Solution
No power 1. Check power is supplying
2. Check fuse F1 open
1. If supplying power differs from machine’s power
rating, replace the machine.
2. Replace it.
Fuser Error 1. Thermostat open
2. AC wire open
3. Thermistor wire open
4. Main PBA
1. Detach AC connector and measure the resistane
between pin 1 and 2. If it is megohm, thermostat
is open, Replace it.
2. Check bad connector contact or wire is cut.
3. Check thermistor wire and its connection.
4. Replace Main PBA
Cover open
1. When close Side cover, check the
lever is pressed
2. Micro switch’s contact
3. CPU and related circuit
1. Open Side cover and press the lever with pen.
If Controller detects cover close, there is some
mechanical trouble in Side cover and lever’s
assembly. If not so there is electrical problem.
Jam 0 Check where Jam 0 happens
1. Paper is not picked up
2. Paper is located in feed sensor
3. Happened when inserting specic
papers such as envelope into the
MPF (Multipurpose Paper Feeder)?
4. Happened when inserting specic
papers such as envelope into the
Manual Feeder?
5. Is the Stacker Extender is folded
out?
6. Does not the Guide Adjust distort the
papers
1. Check whether solenoid is working or not by using
Engine test mode
2. Check feed sensor malfunction.
3. Re-try inserting a fewer papers.
• fan the papers and align
• take out the loaded papers and insert them
reverse direction
4. Take out the loaded papers and insert them
reverse direction
• inserted papers as recommended for Manual
Feeding?
• When loading, tap the papers until paper detect
sensor senses loading
5. When using long papers, use the Stacker
Extender
6. Adjust Guide to t the paper width
Jam 1 Paper is stopped in just after of fuser
unit.
1. It is mostly resulted from double feeding.
Check paper is well stocked in feeder.
2. Check feed actuator position and actuator’s
operating. There may be stiff movind or double
reection. If not so, check the operation of feed
sensor by Engine test mode.
3. Check exit lever operation. Remore jam and
check actuator moving by hand. If actuator is
too stiff, paper is wrapped around the heat roller.
Remove obstacles or replace.