SAMSUNG | 33
INSTALLATION
5
Installation Diagram of Indoor Unit and Outdoor Unit (cont.)
5-2-3. Connecting the Assembly Cable (Cooling Only)
The outdoor unit is powered from the indoor unit via the assembly cable. (7K/9K/12K)
5-2-4. Connecting the Assembly Cable (Heat Pump)
The outdoor unit is powered from the indoor unit via the assembly cable. (7K/9K/12K)
1. Extend the assembly cable if necessary.
2. Open the front grille by pulling on the tab on the lower right and left sides of the
indoor unit.
3. Remove the screw securing the connector cover.
4. Pass the assembly cable through the rear of the indoor unit and connect the assembly
cable to terminals.
◆
Each wire is labeled with the corresponding terminal number.
5. Firmly fix the ass'y cable with clamp wire holder.
6. Pass the other end of the cable through the 65mm hole in the wall.
7. Replace the connector cover, carefully tightening the screw.
8. Close the front grille.
9. For further details on how to plug the other end of the assembly cable into the
outdoor unit.
Indoor
unit
Outdoor
unit
1. Extend the assembly cable if necessary.
2. Open the front grille by pulling on the tabs on the lower right and left sides of the
indoor unit.
3. Remove the screw securing the connector cover.
4. Pass the assembly cable through the rear of the indoor unit and connect the
assembly cable to terminals.
◆
Each wire is labeled with the corresponding terminal number.
5. Pass the other end of the cable through the 65 mm hole in the wall.
6. Replace the connector cover, carefully tightening the screw.
7. Close the front grille.
8. For further details on how to plug the other end of the assembly cable into the
outdoor unit.
N(1)
12
N(1)
123
3
E231
N1
E
2
31
1
N1N1
N1
Indoor
unit
Outdoor
unit
DB98_16444A(1)_1 2/9/04 10:04 AM Page 33
To Next Page
Loading...
