overview
12_ overview
Components
Item Description
Micro SD Memory
Card Compartment
Compartment for the
Micro SD memory card.
b
Monitor Out
Using the test monitor cable, you can connect to a mobile display for camera
test.
(for installation)
c
Reset Button
Resets the camera settings to the default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
Wiring Cover Arrange the cables through this hole.
To Next Page
Loading...
