24_ camera setup
camera setup
DAY/NIGHT
You can specify a recording mode according to the scene.
For selecting and saving each menu item, refer to "How to use the keyboard controller". (page 20)
Select <CAMERA SET> - <DAY/NIGHT>.
Select a screen transition mode according to
the illumination, and set options as appropriate.
DAY : Fixed to DAY mode, regardless of the
scene.
NIGHT : Fixed to NIGHT mode, regardless
of the scene.
If BURST is set to <ON>, the burst signal will
output.
AUTO : According to the luminance, this will
switch DAY to NIGHT mode, or vice versa.
DAY
NIGHT / NIGHT
DAY : If set to
<AUTO>, you can specify the brightness
level triggering the mode switch between
DAY and NIGHT as well as the interval.
MASK AREA : If there exists a bright spot
light source in a night scene, you can specify
the size and position as needed.
Any excessively bright area in a night scene
will be masked.
1.
2.
y
y
y
y
y
To Next Page
Loading...
