What to do if no signal is found at the Alarm Output port of Samsung Security Camera?
If no signal is found at the Alarm Output port of your Samsung Security Camera even when an event is generated, check the alarm output port settings.
Why can't I access my Samsung SND-3082 Security Camera from a web browser?
If you're unable to access the camera via a web browser, verify the camera's network settings are correct. Also, ensure all network cables are properly connected. If using DHCP, confirm the camera obtains dynamic IP addresses without issues. For connections through a Broadband Router, check that port forwarding is configured correctly.
What to do if viewer got disconnected during monitoring Samsung SND-3082 Security Camera?
If the viewer gets disconnected during monitoring, first check all network connections. This issue can occur if connected viewers disconnect when there are changes to the camera or network configurations. If the camera is connected over a PPPoE network, viewer disconnection can also happen under poor network conditions.
What to do if Samsung SND-3082 connected to the network is not detected in the IP installer program?
If the camera is connected to the network but not detected in the IP installer program, try turning off the firewall settings on your PC and then search for the camera again.
How to fix overlapping images on Samsung SND-3082?
If you're experiencing overlapping images, check whether multiple cameras are set to the same multicast address instead of unique ones. Ensure each camera has its own distinct multicast address.
General| Brand | Samsung |
|---|---|
| Model | SND-3082 |
| Category | Security Camera |
| Language | English |
To Next Page