6. Configure the operations to be executed when an event is detected.
• FTP : To set whether or not to send FTP when an event is detected.
`
Refer to “FTP / E-mail” for more details. (page 105)
• E-mail : To set whether or not to execute transmission when an event is detected.
`
Refer to “FTP / E-mail” for more details. (page 105)
• Record : To set whether or not to record to a NAS or Micro SD card when an
event is detected.
`
Set <Device> to <On> in <Storage>. (page 107)
7. When done, click [Apply (
)].
J
`
The default tampering detection function may not work properly in the following cases:
-
Under circumstances of simple background or low illumination and night time may lower the
detection sensitivity.
-
A severe shaking of the camera or a drastic change to the illumination can be considered a
tampering by mistake.
-
Detection of the tampering may take some time (maximum 5 seconds) right after the
tampering was made.
-
Once a tampering is detected, the camera will resume a normal operating after a certain
stability time (approx. 5 seconds) during which no detection will be performed.
setup screen
116_ setup screen
To Next Page
Loading...
