Samsung SPD-3750T - Ssnr(Samsung Super Noise Reduction)

SPEED DOME CAMERA User’s Manual
46
SPEED DOME CAMERA User’s Manual
47
Camera Setting
①Focus & Zoom
White Balance ATW
③Exposure
④Back Light OFF
AGC Medium
SSNR Medium
⑦Day & Night
⑧Others
Main Menu
①Camera Setting
②Sequence Setting
③P/T Setting
④OSD Setting
⑤Alarm Setting
⑥Initialize
Status
➡
6. SSNR (Samsung Super Noise Reduction)
 ▶
Main Menu/Camera Setting/SSNR
SSNR significantly reduces the amount of low luminance noise.
- Off : Disables the noise reduction function.
- Low : Reduces only a small amount of noise, but generates
almost no afterimage.
- Medium : The most commonly used mode. Reduces a suitable
amount of noise while generating a subtle
afterimage.
- High : Reduces noise significantly, but generates obvious
afterimages.
•SSNRisdisabledwhentheAGCmodeisturnedoff.
Notes
Color -> B/W B/W -> Color
Fast 2.5Lux 4Lux
Slow 0.8Lux 6Lux
Camera Setting
①Focus & Zoom
White Balance ATW
③Exposure
④Back Light OFF
AGC Medium
SSNR Medium
⑦Day & Night
⑧Others
Day & Night
①Mode COLOR
Duration FAST
③Dwell Time 0.5 SEC
Main Menu
①Camera Setting
②Sequence Setting
③P/T Setting
④OSD Setting
⑤Alarm Setting
⑥Initialize
Status
➡
➡
7. Day & Night
 ▶
Main Menu/Camera Setting/Day & Night
•TheAutomodeisdisabledwhenAGCisturnedoff.Thisfunctionisonlyavailablewhen
the Color or B/W mode is selected.
•UsingB/Wmodeundersunlightorahalogenlampmaydecreasethefocusing
performance.
Notes
The Day & Night function allows the camera to switch
between the Color and B/W modes.
Modes
:
- Auto : Operates in Color mode most times, and switches
to B/W mode if a low light level is detected during
nighttime.
- Color : Operates in Color mode at all times.
- B/W : Operates in B/W mode at all times. By using the
Burst On/Off sub menu, burst signals can be
retained or disabled.
Duration
:
The camera’s light sensitivity is adjustable as in the chart
below. The camera’s ambient light diversion performance
may vary depending on its environment.
Dwell Time
:
The duration of both the lighting conditions can be
customized to let the camera divert between the daytime
and nighttime settings.
✽ If the camera is in B/W mode and connected to equipment
that requires external sync through burst signals, set the
Burst On/Off option to “On.”
Functional Description Functional Description