60 2B. Making and Answering Calls
In-Call Options
Once you initiate a call, you
will see six onscreen options.
Tap an option to select it.
䢇 Add call touch and hold to
initiate a 3-way call
(page 163).
䢇 Merge to join two currently
active calls (conference).
䢇 Dialpad/Hide to toggle the
appearance of the onscreen
dialpad.
䢇 End call to end the current
call.
䢇 Speaker to route the device’s audio through the
speaker (
On) or through the earpiece (Off).
䊳 Activate Speaker to route the device’s audio
through the speaker. (You can adjust the speaker
volume using the volume buttons.)
䊳 Deactivate Speaker to use the device’s earpiece.
䢇 Mute to mute the microphone during an active call.
Tap again to unmute the microphone.
䢇 Bluetooth to route the device’s audio through a
connected Bluetooth headset (
On) or through the
speaker (
Off). (See “2J. Bluetooth” on page 143.)
䡲 When the call is routed to a Bluetooth headset,
the current call area shows the
Bluetooth call
icon ( ).
● To route the current call back to the device,
tap
Headset to temporarily use the device. Tap
it again to route the call back to the connected
Bluetooth headset.
䡲 When Bluetooth or the Bluetooth headset is
turned off, the call is routed through either the
earpiece or speaker and shows ( ).
WARNING: Because of higher volume levels, do not place
the device near your ear during speakerphone
use.
Note: If Mute is activated, the speaker mode is deactivated.
Note: The Headset button is activated to show the current call
is routed to the connected Bluetooth headset.
SPH-D700.book Page 60 Friday, August 6, 2010 3:57 PM
To Next Page
Loading...
