Samsung ST80 - 5 Adjustment; Basic Guide for Adjustment

SAMSUNG This Document can not be used without Samsung’s authorization 5-1
Adjustment
5. Adjustment
■ After you replace the electronic parts, you must make adjustments for each adjustment item in ST80.
■ The following table shows the necessary adjustment item for replacing each part.
1. After replacing the electronic part, you must make adjustments for each item by referring to the following table.
<Table 5-1>
MAIN
PCB
POWER
PCB
BARREL
ASSY
CCD
ASSY
FIRMWARE UPGRADE ● ●
PUNT ADJ, BACKLASH ● ● ●
SHUTTER CLOSE TIME, OB, LENS SHADING ● ● ●
FLASH ADJ ● ● ● ●
BATTERY LEVEL ADJ ● ●
CCD DEFECT PIXEL ● ● ● ●
SERIAL NUMBER WRITING ●
2. Adjustment equipment
- AE TESTER: AE TESTER that enables LV 12
 -InnityCallimatorforPUNTadjustment
- Gray chart (18%) for FLASH & AWB, DARK BOX)
- POWER SUPPLY: 3.2V / 2A
3. Adjustment program le
Save and use the program for each adjustment item on the microSD™ card to adjust each item.
 Thelenameforeachadjustmentitemisthesameas“ST80_ADJ.TXT”.
5-1 Basic guide for adjustment