Samsung ST80 - Punt Adj

SAMSUNG This Document can not be used without Samsung’s authorization 5-7
Adjustment
5-7 PUNT ADJ
■ Adjustment objective: After replacing the MAIN PCB and BARREL, you must decide the AF search range so that the optimal
  focuscanbeidentiedbythebodytube.
■ Necessary equipment: InnityCallimator
<Adjustment method>
1. Save the adjustment le to the microSD™ card and install it on the camera.
2. Refer to the following adjustment environment specication to adjust the focus.
1) Used specication of Innity Callimator
  -SettheilluminancespecicationoftheCallimatorto6LV.
  -Maintaindistanceoflessthan1cmbetweentheendofthecamerabodytubetothelenssurfaceoftheInnityCallimator.
  -Thecameramustbexedwhiletheadjustmentismade.
2) Used specication for innite object
  -Thecameramustbexedwithatripodandleveledconditionmustbemaintained.
  -Setupthecameratowardabuildingorobjectininnitedistance(morethan500m).(Donotusethechart)
- Set a cathedral, partment or object with high contrast in day environment/AF area display.
Fig. 5-4
Innity Callimator
Camera
Tripod