Samsung ST80 - Shutter Close Time ADJ

SAMSUNG This Document can not be used without Samsung’s authorization 5-5
Adjustment
5-5 Shutter Close Time ADJ
■ Adjust the Close timing of the device shutter by camera.
■ Because there is a deviation of shutter closing time by each set, make adjustments by each set to reduce this deviation.
■ AWB LOW item and AWB LOW are adjusted simultaneously.
<Adjustment method>
1. Prepare the AE TESTER that can be adjusted to LV 12.
2. Install the camera to the AE TESTER.
 *LuminancespecicationoftheLightboxis12LV.
 *ThecolortemperaturespecicationoftheLightboxis3300K.
3. After inserting the microSD™ card containing the program le to the camera, turn on the power of the camera.
4. The adjustment process will automatically start.
qRefer to the specication (Illiminance) for testing.
  -LinedelayandSubdelayareadjustedsothattheappropriatevaluecanbeidentiedtothespecicationilluminance.
wIf the result line delay wis within the min and max range, it is OK. If it is outside of the range, process as NG.
eRefer to the EEPROM WRITE information and write the adjustment result to EEPROM.
rRefer to the CARD WRITE INFORMATION to write the adjustment result to the data le.
5. When the adjustment is completed, the camera will automatically be turned off.
<Adjustment result>
Open and check the CSV le generated from the adjustment memory card.
<Restriction>
If the capacity of CSV le is more than 30KB, clear all of the previous data and then, record
Fig. 5-2
Light source box
Camera