5-1-2 Required Equipment
The following equipment may be necessary for
adjustment procedures:
5-1-2 (a) DISPLAY CONTROL ADJUSTMENT
1. Non-metallic (–) screwdriver: 1.5 mm
Non-metallic (–) screwdriver: 3 mm
2. Philips (+) screwdriver: 1.5 mm
3. Non-metallic hexkey: 2.5 mm
4. Digital Multimeter (DMM), or
Digital Voltmeter (DVM)
5. Signal generator, or
Computer with a video board that uses the
ET-4000 chipset (strongly recommended if
using Samsung DM 200 software) and that
displays: 800 x 600 @ 85 Hz, or 800 x 600
@ 75 Hz (minimum).
6. Personal computer
7. Required software: Softjig.exe from Samsung,
Samsung DM200, or DisplayMate for
Windows from Sonera Technologies
8. Interface Board Ver. 2.0 Code No.
BH81-90001K
9. Parallel communications cable (25-pin to
25-pin); Code No. BH81-90001H
10. Signal cable (15-pin to 15-pin cable with
additional 3-pin connector); Code No.
BH81-90001J
11. 5 V DC adapter, not supplied
Note: SoftJig Assembly (includes items 8, 9 and 10
Code No. BH81-90001L
5.1-2 (b) COLOR ADJUSTMENTS
1. All equipment listed in 5-1-2 (a), above
2. Color analyzer, or any luminance
measurement equipment
5 Alignment and Adjustments
5-2 CKA42*7L/5227L
To Next Page
Loading...
