4-10
4. Troubleshooting
Service Mode (Replacing the Panel)
- When replacing the panel
After replacing the panel, select the Panel item and then hold down the Menu button for ve (5) seconds.
The Ch. No. of the panel will increase by one (1) and the time information will change to 0.
Service Mode (Hot plug Menu)
- HDCP Hotplug : used when HDCP Video contents are not displayed. In case that monitor is connected to some bad
device which does not comply with standard.
- HotPlug Time : If Hotplug is turn on, when monitor power off/on or changing to the DVI, hotplug pin goes to the low. This
function controls this time duration.
Though Hotplug is turn on monitor can’t displayed, adjust this time duration
- Default is 9(means 0.9 sec), can control 5 to 50.
To Next Page
Loading...
