4-9
4. Troubleshooting
4-6-2. Service Function Spec.
Service Mode (Entering)
1. Set both the brightness and contrast to 0.
2. Hold down the <Button>(Enter, Source) button for ve (5) seconds.
3. The SVC Function OSD will appear.
- To exit the SVC Function OSD, you have to turn off the power.
The SVC Function OSD consists of a 29 (width) X 12 (height) grid.
The SVC Function OSD shows the information, software version and Micom checksum.
Service Mode (Moving around)
1. Each time the + button is pressed, menu is selected. Then, you can adjust sub menu with - button
Panel Information
MCU Version
Checksum
To Next Page
Loading...
