2
3
4
5
3
1
Turn off your computer and unplug
the power cord.
2
Video port
Connect the signal cable (with an
adapter if necessary) to the video port
on the back of your computer, video
board, video card, or graphics card.
3
Signal cable
Connect the end of the signal cable to
your computer’s video port. If you are
using a Macintosh computer, connect
the cable to a Macintosh adapter, and
set the pins on your adapter (adapter
not included). An IBM-compatible
computer does not need an adapter.
4
Power port
Connect the power cord for your
monitor to the power port on the back
of the monitor.
5
Power cords
Plug the power cord for the monitor
and the power cord for your computer
into a nearby outlet.
6
Turn on your computer and monitor.
If your monitor displays an image,
installation is complete.
To install the monitor driver on your PC:
1. Insert the provided diskette into the A drive.
2. Double click the “install.exe” file.
Connecting Your Monitor
Please make sure the following items are included with your monitor.
If any items are missing, contact your dealer.
This manual
Power cord
Monitor & stand
Warranty card
(not available in all locations)
Driver installation diskette
2
510/710-E 7/21/98 3:23 PM Page 2
To Next Page
Loading...
