21
English
Screen is blank and
power indicator light is
steady amber or blinks
every 0.5 or 1 seconds
n The monitor is using its power
management system.
n Move the computer’s mouse or
press a key on the keyboard
PowerSaver,
page 19.
Image is not stable and
may appear to vibrate
n Check that the display resolution
and frequency from your PC or video
board is an available mode for your
monitor. On your computer check:
Control Panel, Display, Settings
Display Mode,
page 17.
Display Modes,
page 26.
n If the setting is not correct, use your
computer utility program to change
the display settings.
Installing the Video
Driver, page 7.
NOTE: Your monitor supports multiscan display functions
within the following frequency domain:
n Horizontal frequency:
n Vertical frequency:
n Maximum refresh rate:
30 kHz – 61 kHz
50 Hz – 75 Hz
1024 x 768 @ 75 Hz
Image is not centered
on the screen.
n Adjust the horizontal and vertical
position.
H-Position, page 14.
V-Position, page 14.
You need the monitor
driver software
n Download the driver from the internet
at:
http://www.samsungelectronics.com
Table 5. Troubleshooting problems – Image (
Continued
)
What you see... Suggested Action Reference
Appendix
E Page 21 Friday, August 11, 2000 2:44 PM
To Next Page
Loading...
