• If you connect properly your monitor using the DVI connector but get a blank or fuzzy screen,
check to see if the monitor status is set to analogue. Press 'SOURCE [ ]' button to have the
monitor double-check the input signal source.
Connecting to a Macintosh
1. Using the D-sub (Analog) connector on the video card.
• Connect the signal cable to the D-SUB port on the back of your monitor.
[PC]
Note
Turn on the monitor and Macintosh.
Connecting to Other devices
Note
• This monitor allows the user to connect it to such input devices as a DVD player, a VCR or cam-
corder, or a DTV or TV without disconnecting the PC.
• The configuration at the back of the monitor may vary from product to product.
• The DVI to HDMI cable, digital audio optic output cable, and RCA to stereo (for PC) cable are all
sold separately. Contact a Service Center to purchase any products sold separately.
Connecting TV
Note
You may view television programs on the monitor if it is connected to an antenna or CATV cable
without installing any separate TV reception hardware or software on your computer.
Connections
To Next Page
Loading...
