White Ratio (Balance) Adjustment
You can adjust the white ratio in factory mode (1:Calibration, 3:White-Balance).1.
Since the adjustment value and the data value vary depending on the input source, you have to adjust these in CVBS, 2.
Component 1 and HDMI 1 modes.
The optimal values for each mode are congured by default. It varies with Panel’s size and Specication.3.
Equipment : CA210•
Pattern: MIK K-7256 #92 “Flat W/B Pattern” as standard•
NOTE
Use other equipment only after comparing the result with that of the Master equipment.
Set Aging time : 60min•
Calibration and Manual setting for WB adjustment.
HDMI : Calibration at #24 Chessboard Pattern → Manual adjustment #92 pattern (720p)•
COMP: Calibration at #24 Chessboard Pattern → Manual adjustment at #92 pattern (720p)•
CVBS: Calibration at #24 Chessboard Pattern→ Manual adjustment at #92 pattern (NTSC)•
NOTE
If nishing in HDMI mode, adjustment coordinate is almost same in AV/COMP mode.•
4-42
4. Troubleshooting
4-43
4. Troubleshooting
4-42
4. Troubleshooting
4-43
4. Troubleshooting
To Next Page
Loading...
