Manual Tuning
Scans for a channel manually and stores in the TV.
✎
If a channel is locked, the PIN input window appears.
✎
According to the channel source, Manual Tuning may be supported.
When Antenna Source is set to Air or Cable:
• Digital Channel Tuning: Scans for a digital channel manually and stores in the TV. Press the New button to search
the digital channels. When scanning has finished, a channel is updated in the channel list.
– When selecting Aerial → Air: Channel, Frequency, Bandwidth
– When selecting Aerial → Cable: Frequency, Modulation, Symbol Rate
When Antenna Source is set to Satellite: (for TD310ES model)
• Transponder: Selects the transponder using the up/down buttons.
• Scan Mode (All Channels / Free Channels Only): Selects either free or all channels to store.
• Network Search (Disable / Enable): Enable / Disable network search using the up/down buttons.
• Signal Quality: Display the current status of broadcasting signal.
✎
Information on a satellite and its transponder is subject to change depending on the broadcasting conditions.
✎
When setting is completed, move to Search and press the ENTER button. Channel scan is started.
• Analogue Channel Tuning: Scans for an analogue channel. Press the New button to search the channels by
adjusting the Programme, Colour System, Sound System, Channel, Search.
✎
Channel mode
– P (programme mode): When tuning is complete, the broadcasting stations in your area have been assigned to
the position numbers from P0 to P99. You can select a channel by entering the position number in this mode.
– C (aerial channel mode) / S (cable channel mode): These two modes allow you to select a channel by entering
the assigned number for each aerial broadcasting station or cable channel.
English - 42
To Next Page
Loading...
