Switching between Anynet+ Devices
1. Open the Tools menu using your remote, and then select Anynet+ (HDMI-CEC).
2. Select a device, and then wait until the switch to the selected device is completed.
✎
The menu appears only when you set Anynet+ (HDMI-CEC) to On in the System menu.
✎
Switching to the selected device may take up to 2 minutes. You cannot cancel the switching operation while
switching is in progress.
✎
If you have selected an Anynet+ device using the Source function , you cannot use the Anynet+ function.
Make sure to switch to an Anynet+ device.
English - 68
To Next Page
Loading...
