30
Section 5: Voice Service
VoiceSignal is state-of-the-art voice recognition software for your mobile phone that
lets you dial numbers, lookup contact information, and open applications using your
voice. To access your phone’s voice settings, do the following:
䊳
In standby mode, press Menu ➔ Tools ➔ Voice SVC ➔ Voice Commands.
– or –
In standby mode, press and hold .
“
Say a Command
” appears in the display and is pronounced through the earpiece,
followed by a list of available commands.
Note:
Speaking clearly, say the command that you want to use. If, after a few seconds, the device
does not recognized a command, it prompts you to repeat the command.
If, after a few more seconds, it still does not recognize a command, it tells you “
Sorry, no
match found
,” and cancels voice recognition.
Voice-Activating Your Contacts List
When you first start VoiceSignal, it reads your Contacts list and voice-activates all
the names stored there. When you have add or change contacts, VoiceSignal
automatically reloads and voice-activates the entire list.
Ending Calls Before Restarting the VoiceSignal Software
When you use VoiceSignal to make a call, you must end that call before you can use
VoiceSignal again.
To Next Page
Loading...
