4-2-5. Jog Function Control
Jog Function Control
Press
Center
Left
Vol+
Right
Vol-
Up
CH+
Down
CH-
Jog Function Control Test
Check Jog Shuttle STBY Voltages (All at 1.8VDC except LED)1.
Check Jog Shuttle 5 SW Operation Key1 & Key 2 for each command change. (See Chart)2.
Check LED active during STBY (1.8VDC )3.
Pin CMD Signal DC Voltage
1 Center Key 1 1.8VDC to 0.0V DC
2 Vol+ Key 2 1.8VDC to 1.0V DC
2 Vol- Key 2 1.8VDC to 1.5V DC
2 CH+ Key 2 1.8VDC to 0.0V DC
2 CH- Key 2 1.8VDC to 0.5V DC
3 GND
To Next Page
Loading...
