Connecting VHF and UHF Antennas
Ifyour antenna has a set of leads that look like the diagram to the right, see 'Antennas with 300
O Flat Twin Leads' below.
Ifyour antenna has one lead that looks like the diagram to the right, see 'Antennas with 75 O
Round Leads'.
Ifyou have two antennas, see 'Separate VHF and UHF Antennas'.
Antennas with 300 _ Flat Twin Leads
Ifyou are using an off-air antenna (such as a roof antenna or 'rabbit ears') that has 3000 twin
flat leads, follow the directions below.
1. Place the wires from the twin leads under the screws on a 300-75 O adapter (not
supplied). Use a screwdriver to tighten the screws.
2, Plug the adaptor into the ANT IN terminal on the back of the TV.
Antennaswith 75Q RoundLeads
PlugtheantennaleadintotheANTmNterminalonthebackoftheTV.
Separate VHF and UHF Antennas
Ifyou have two separate antennas for your TV (one VHF and one UHF), you must combine
the two antenna signals before connecting the antennas to the TV. This procedure requires an
optional combiner-adaptor (available at most electronics shops).
1, Connect both antenna leads to the combiner.
2, Plug the combiner into the ANT IN terminal on the bottom of the rear panel.
To Next Page
Loading...
