Connecting Cable TV
To connect to a cable TV system, follow the instructionsbelow.
Cablewithout a CableBox
Plug the incomingcable into theANT iNterminal on the back of the TV.
Because this TV is cable-ready, you do not need a cable box to view unscrambled cable
channels.
Connecting to a Cable Box that Descrambles All Channels
1, Find the cable that is connected to the ANT OUT terminal on your cable box.
This terminal might be labeled 'ANT OUT', 'VHF OUT' or simply, =OUT'.
[::,::..............................................................
2, Connect the other end of this cable to the ANT iN terminal on the back of the TV.
Connecting to a Cable Box that Descrambles Some Channels
Ifyour cable box descrambles only some channels (such as premium channels), follow the instructions below. You will need a two-
way splitter, an RF (A/B) switch and four lengths of RF cable. (These items are available at most electronics stores.)
Incoming cable IN CABI_
CableBox
RF(A/B) Switch
1, Find and disconnect the cable that is connected to the ANT IN terminal onyour cable box.
This terminal might be labeled 'ANT IN', 'VHF IN' or simply, 'IN'.
2, Connect this cable to a two-way splitter.
3, Connect an RF cable between the OUTPUT terminal onthe splitter and the IN terminal on the cable box.
4, Connect an RF cable between the ANT OUTterminal on the cable box and the B-IN terminal onthe RF(A/B) switch.
& Connect another cable between the other OUT terminal on the splitter and the A-IN terminal on the RF (A/B) switch.
6, Connect the last RF cable between the OUT terminal on the RF (A/B) switch and the ANT INterminal on the rear of the TV.
After you have made this connection, set the A/B switch to the 'A' position for normal viewing. Set the A/B switch to the 'B'
position to view scrambled channels. (When you set the A/B switch to 'B', you will need to tune your TV to the cable box's
output channel, which is usually channel 3 or 4.)
To Next Page
Loading...
