Troubleshooting for Anynet +
Problem'
Anynet + does not work.
Iwant to start Anynet+.
Iwant to exit Anynet +.
The message 'Connecting to
Anynet+ device...' appears on
the screen.
The Anynet+ device does not
play.
The connected device is not
displayed.
Possible Solution
• Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+ devices only.
• Connect only one receiver (home theater).
• Check if the Anynet+ device power cord is properly connected.
• Check the Anynet+ device's Video/Audio/HDMI 1.3 cable connections.
• Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.
• Check whether the TV remote control is in TV mode.
• Check whether it isAnynet + exclusive remote control.
• Anynet + doesn't work in certain situations. (Searching channels, Operating Media Play, Plug &
Play, etc.)
• When connecting or removing the HDMI 1.3cable, please make sure to search devices again or
turn your TV off and on again.
• Check if the Anynet+ Function of Anynet+ device is set on.
• Check if the Anynet+ device is properly connected to the TV and check if the Anynet + (HDMI-
CEC) is set to On in the Anynet + Setup menu.
• Press the TV button on the TV remote control to switch to TV. Then press the TOOLS button to
show the Anynet + menu and select a menu you want.
• Select View TV in the Anynet + menu.
• Press the SOURCE button on the TV remote control and select a device other than Anynet +
devices.
• Press v CH A, CH LIST, PRE-CH, and FAV.CHto change the TV mode. (Note that the
channel button operates only when a tuner-embedded Anynet + device is not connected.)
• You cannot use the remote control when you are configuring Anynet+ or switching to a view
mode.
+
• Use the remote control when the Anynet setting or switching to view mode is complete.
• You cannot use the play function when Plug & Play is in progress.
The TV program cannot be •
recorded.
The TV sound is not output • Connect the optical cable between TV and the receiver.
through the receiver.
• Check whether or not the device supports Anynet+ functions.
• Check whether or not the HDMI 1.3cable is properly connected.
• Check whether Anynet + (HDMI-CEC) is set toOn in theAnynet + setup menu.
• SearchAnynet + devices again.
• You can connect an Anynet+ device using the HDMI 1.3 cable only. Some HDMI cables may not
support Anynet+ functions.
• Ifit is terminated by an abnormal situation such as disconnecting the HDMI cable or power cord
or a power failure, please repeat the device scan.
Check whether the antenna jack on the recording device is properly connected.
To Next Page
Loading...
