✤
✤
1. TAPE EJECT
■
■
2.
3.
4.
BATTERY RELEASE
ENGLISH
110
110
Maintenance
✤ At the end of a recording you must remove the
power source.
✤ When recording with a Lithium ion Battery pack,
leaving the pack on the Camcorder can reduce the
life span of the battery. The Battery pack should be
released after recording is completed.
1. Slide the TAPE EJECT switch in the direction of
the arrow and open the cassette door until it clicks.
■
Opening the cassette door ejects the tape
automatically.
■
Please wait until the tape is completely ejected.
2. After removing the tape, close the door and store
the Camcorder in a dust free environment.
Dust and other foreign materials can cause square-
shaped noise or unstable images.
3. Set the Power switch to the OFF.
4. Disconnect the power source or remove the
Lithium ion Battery pack.
Press the BATTERY RELEASE button located on
the left side of the Camcorder while pushing the
Battery pack in the direction of the arrow.
After Finishing a Recording
1
2
3
4
To Next Page
Loading...
Need help?
General
