16 _ Disassembly and Reassembly
Part Figure Description
Clutch (continued)
6. Remove the shaft with the jig wrench.
- Release the nut in a clockwise direction.
- Fasten the nut in a counterclockwise
direction.
7. Place the main body so that the front
frame faces upward and remove the 2
bolts holding the saddle with a 10mm
wrench.
When you place the washer on
theoor,takecarethatyoudonot
damage or scratch the product.
8. Remove the belt.
When you replace belt, check belt
tension certainly.
9. Remove the NUT with a 17mm wrench
and remove Assy pulley motor.
To Next Page
Loading...
