Disassembly and Reassembly _ 15
Part Figure Description
Clutch (continued)
1. Separate the top cover assembly by
lifting and pushing ahead the top part of
the assembly.
2. Remove the 2 screws holding the panel
control Separate all the wires connected
to the housing.
3. Removethe9screwsxingthetub-
cover and separate the tub-cover.
4. Separate the pulsator-cap by inserting
the tip of a (-) screwdriver between the
pulsator-cap and the pulsator.
5. Remove the bolt holding the pulsator
with a 10mm wrench according to the
direction of arrow.
To Next Page
Loading...
